This is an old revision of the document!
Built-in G code
* G00
- G80: End of drilling cycle
- G83: Z-direction drilling cycle on the end face
- G84: Z-direction tapping cycle on the end face
- G87: Side X-direction drilling cycle
- G88: Side X-direction tapping cycle
- G76: Turning cycle (support chip breaking function after the new generation 25)
- G92: Turning cycle (new generation 25 version supports chip breaking function)
- G74: Pecking cutting cycle / chip breaking cutting cycle (new generation 22 version later)
- G71: Stock Removal in Turning