User Manual

Table of Contents

SYNTEC MT Series Manual

Machine Operational Manual

Please Note: Some chapters from the MT Series Operational Manual are only for the FANUC Controller, therefore, please find the related information through SYNTEC official controller Manual.

SYNTEC Controller Manual

Operation Pannel

  1. USB Port
  2. LCD Screen
  3. FMenu bar keys
  4. Switch function Keys
  5. Reset Key
  6. Address-numeric Keypad
  7. Page Keys
  8. Cursor Keys
  9. Editing Keys
  10. MPG
  11. Cycle Start/Stop Buttons
  12. Mode Keys
  13. Feedrate keys
  14. Axis Select keys
  15. G1 Feedrate keys
  16. G0 Feedrate keys
  17. Spindle Speed keys
  18. Spindle Control keys
  19. Not Used
  20. Light On/Off
  21. Lubrication On/Off
  22. Chip On/Off
  23. Chuck Open/Close
  24. Coolant On/Off
  25. Not Used
  26. Optional Stop
  27. Optional Skip
  28. Single Block
  29. MPG Simulation
  30. Livetool A On/Off (JOG/MPG)
  31. Livetool B On/Off (JOG/MPG)
  32. F1: Auto Door Open/Close
  33. F2: Dry Run
  34. F3: Machine Lock
  35. F4: Air Blow
  36. Overtravel Button
  37. F5: Not Used
  38. Program Lock key
  39. Power On/Off Buttons
  40. Emergency Stop Button

COMBO Key

  1. C Axis On/Off: JOG Mode → [C+][C-]

Custom G Code

  • G101: Hex Milling

Custom M Code

  • M00: Feed Hold
  • M01: Optional Stop
  • M02: Program Stop
  • M03: 1th Spindle CW
  • M04: 1th Spindle CCW
  • M05: 1th Spindle STOP
  • M06: Set Main Spindle to 1th Spindle
  • M08: Coolant Pump On
  • M09: Coolant Pump Off
  • M10: Chuck Open
  • M11: Chuck Close
  • M19: Spindle Orientation (Pr1751 set degree)
  • M22: CS Off
  • M23: CS On
  • M30: Cycle End
  • M31: Barloader Start
  • M33: Live Tool B CW
  • M34: Live Tool B CCW
  • M35: Live Tool B STOP
  • M43: Live Tool A CW
  • M44: Live Tool A CCW
  • M45: Live Tool A STOP
  • M46: Set Main Spindle to Live Tool A
  • M48: Robot On
  • M49: Robot Off
  • M64: Door Open
  • M65: Door Close
  • M70: Spindle Jog for Air Blow
  • M88: Air Blow Open
  • M89: Air Blow Close
  • M94: Barloader Back Start
  • M95: Barloader End
  • M98: Sub program Begin
  • M99: Sub program End

Electronic Drawing

Electronic Drawing For 380V 6KVA (UPDATE: 20200527)